Smoke reported near Highway 1; no fire found, Santa Cruz County CA
WildfireFire crews responded to a smoke report near southbound Highway 1 close to Riverside Drive. After checking the area, no fire was found. The incident was confirmed as a false alarm.
Audio|Source: CalFire CZU - Dispatch, Command, Air Attack, Air to Ground
01:30
Transcript:
00:00
A smoke check[1] in the area of Highway 1, Riverside.
00:19
Battine 1714. Notification only, engine 4211, respond with engine 411 en route for a smoke check[1] in the area of southbound Highway 1 north of Riverside, a single report at 10.30.
00:47
Repeating on tone 9 for engine 4211 with engine 411 in route for a smoke check[1] in the area of southbound Highway 1 near Riverside Drive for a single report at 1030.
01:06
Edge 4211 at 1031.
01:09
Perce, HB, their UTL[2] from 1 to Green Valley to the county line.
01:14
Information only.
01:18
4211.
01:19
4211, Felton.
01:27
Per engine, 4411, they were UTL[2]. You can cancel, acknowledge.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
smoke check: Investigation of reported smoke with no confirmed fire
[2]
UTL: Unable to Locate
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
CA-1, California
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
