Fire alarm triggered by authorized pipe cutting at City Hall, Fairview Heights IL
Fire & ArsonA fire alarm activated at Fairview City Hall on Bunkum Road was caused by authorized workers cutting pipes with a torch during duct work. There was no fire or danger reported.
Audio|Source: Fairview Heights Public Safety
01:15
Transcript:
00:00
Fire is en route to City Hall, near Bunkum Road for a fire alarm personal floor.
00:08
Fairview City Hall, near Bunkum Road.
00:11
For general fire first floor activation.
00:16
No key holder contact.
00:19
Attention period fire fire, still alarm[1].
00:22
Fairview City Hall, near Bunkum Road.
00:27
For general fire alarm, first full negative D holder contact, timeout at 830.
00:33
Let's all loading out.
00:39
35 let's use around.
00:44
It would have to be duct work that they're doing on the replacing OAC units and they were cutting pipes with a torch.
01:00
Tony 500 returning.
01:08
DeCon 2501. Assignment complete, people from fluttering, some pipes together for other 8 o'clock. 10-4[2],
01:15
assignment completed 834.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
still alarm: Initial level fire alarm for a reported fire or smoke requiring a standard fire department response
[2]
10-4: Acknowledgement / Affirmative
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Near Bunkum Rd, Fairview Heights, IL 62208
Correct
Incorrect
